Posted on

Electrician for Hot Water Cylinder Repairs: Wiring, Elements & Thermostats

Many of the issues to do with hot water cylinder faults are typically a plumbers domain of expertise. However, electrical power and (re)wiring are of course an Electricians. Common hot water faults are;

  • No hot water at all
  • Water is too hot, or too cold
  • Noisy cylinder

Repairing your hot water cylinder will always be a priority. If it’s your own home you’ll want to enjoy trouble free and predicable hot water. If it’s an investment property you’ll want to resolve the issue for your tenants asap to keep them happy, and ensure you protect your investment by getting the hot water cylinder and system checked out. Common repair services include;

  • Power supply to cylinder check
  • Cylinder wiring & connectivity check
  • Rewiring
  • Element replacement
  • Thermostat replacement

However, not all hot water cylinders can be repaired. Eventually time can take its toll and a replacement unit will be required. When a new hot water cylinder is installed a registered electrician must wire up the cylinder to the power supply

Need an Electrician for your Hot Water Cylinder Repair or Replacement?

Hall Electrical can assist you with your electrical repair call us on 09 379 9198

Posted on

WARNING = DOUBLE ADAPTORS – MULTIBOXES

I go into homes all the time and see multiboxes running multiple appliances and double adapters plugged into each other and then plugged into 1 power point.

Quite often there are extension cords running off through doorways (or secured around the door frame using household pins) into other rooms with another multibox plugged in. This is a recipe for disaster.

When too many things are plugged into one outlet you start overloading the whole electrical system.

Overloading and loose connections are two major causes of electrical fires in New Zealand. The more connections there are between the switchboard and the appliance the more chance of overheating and then catching fire.

You only have your loved ones and friends in your home so why risk it.

The solution:

  • Swap that single power point for a double or quad power point.
  • Install another power point where you need one and eliminate the extension cord.
  • Have an electrician check to see the fuses or circuit breakers are rated to do there correct job.
  • Balance electrical loads so not too much is on one circuit
  • If you use an extension cord don’t use it rolled up as this causes overheating as well
Posted on

Electrician for Security Lighting Repairs: Fault finding, rewiring, bulb, sensor & fixture replacement

When your security lighting is not working properly it can simply be an annoyance that you want fixed or it could be a serious security issue that needs to be resolved ASAP. Either way, security lighting faults are relatively common, and are normally straightforward to resolve. When you’re dealing with electrical power, using an Electrician is a must. Common security lighting faults are;

  • Bulb failure
  • Sensor not working
  • Timer not working
  • Light fixture damage

Repairing your security lights normally starts with quickly testing and tracing the fault. Once an electrician has identified the issue, they can then resolve by cleaning contact points and replacing the necessary parts or the full fixture if required. Once compete, the light operation is tested to ensure everything is working as per normal. Once again you will have security lights that provide you with convenience and security assurance.

Need an Electrician for your Security Lighting Repair?

Hall Electrical can assist you with your electrical repair. Call us on 09 379 9198